Gage R&R Example | Avoid Common Mistakes | Case Study (2024)

Home » » Gage R&R Example

Learn the #1 mistake to avoid and how QI Macros Gage R&R template can help mistake proof your analysis.

Why This Matters: GR&R is only as good as how it's set up.

Example of How to Set Up a Good Gage R&R Study

If My Parts Are So Good, Why Is My Gage R&R So Bad?

Almost every week, we get this question from someone trying to conduct a Gage R&R study because their customers are requiring it. They think if their product is good, their Gage R&R should be too.

You need BAD parts to conduct a GOOD Gage R&R Study

Gage R&R Study Basics

Gage repeatability and reproducibility calculates the total variation (TV) from three factors. It then uses total variation to determine how much variation is attributable to appraisers and equipment (%R&R).

Gage R&R Example

I have dozens of examples, but here's a recent one. The supplier produces parts:

• Target: 43.11
• Tolerance: +/-0.13 (0.26 total)
• USL = 43.11 + .13 = 43.24, LSL = 43.11 - .13 = 42.98

They measured 10 parts with three appraisers. As you can see from the data table below, all parts are only off from the target by a few thousands. NO PART VARIATION.

How do you know if you have enough part variation? NDC should be ≥ 5.

NDC is the Number of Distinct Categories. It is a measurement of the variation in your sample parts. If your NDC is less than 5, there isn't enough part variation to use the Average and Range Method or the ANOVA method to calculate Gage R&R.

QI Macros Gage R&R template contains code to flag when NDC is less than 5.

Even though the parts are good, they are too good to test the measurement system. When we put this data into QI Macros Gage R&R template, built in logic tells us the same thing. The calculations in cells A48:B56 contain the warning "NDC < 5".

Specification Tolerance Method

The alternative is to use the Specification Tolerance Method. The Spec Tolerance equals (USL-LSL).
A one-sided Specification Tolerance equals 2*(USL-Xbar) or 2*(Xbar-LSL). AIAG MSA V3 pg. 116-117.

In this example, the spec tolerance is equal to 0.26. If we input this value into cell B45, we get results using the spec tolerance method in column C.

When you do, there's much more part variation and the NDC will change accordingly. Here is an example of Gage R&R results with a good NDC and usable results.

When to Use With Interaction and Without Interaction

If your p value in Appraiser x Part < 0.05 (or your Alpha), use With Interaction
If your p value in Appraiser x Part > 0.05 (or your Alpha), use Without Interaction

Here's the Point

Gage R&R doesn't measure the quality of your parts, only the quality of your measurement system. If you want customers to trust your part quality, you have to learn how to properly evaluate measurement variation.

QI Macros Draws These Charts Too!